VS03N1 Results
Submitted checklist.txt and checklist.tex is also available |
[Summary | AIPS | Difmap ] |
Abstract
Only 1/2 an hour of GRT data was collected. SH Failure. The are fringes between SH and VSOP. I believe MOP continues to be low (has been out by a factor of 4). In which case a point source could be fitted. It has not. |
|
|
in |
in |
out |
out |
|
FITLD | clint = 0.25 digicor = -1 delcorr = -1 |
|
|
|
|
|
INDXR | cparm = 0, 0, 0.25; |
|
|
|
|
|
ANTAB | infile='antab.txt' |
|
|
|
|
|
APCAL |
|
|
|
|
||
ACCOR | solint 5 |
|
|
|
|
|
CLCAL | refant=1; |
|
|
|
|
Amplitude calibration solutions applied. XX as ref |
CLCOR | opcode 'gain';antenna 0;clcorprm 1.063,0 |
|
|
|
|
|
FRING | docal -1; dparm 2,400,400,0.5,0;aparm(7)=0.1;solint 5,10,15 |
|
|
|
|
Full range searched |
FRING | dparm 2,0,50,50.5,0;aparm(7)=0.1;solint 5 |
|
|
|
|
only sols are 6 6:30 |
FRING | timer 0 6 0 0 0 8 0;aparm(5)=0/1;solint 5 |
|
|
|
|
short range |
SNEDT/SNCOR/CLCAL | refant=2;opc 'zdel/zrat/zphs';interp 'poly' |
|
|
|
|
Phase from SH to VSOP/MOP till 6:30. Note jumps in time mentioned in log file. Could be whole seconds? |
FRING | timer 0/timer 0 4 0 0 0 6 0;dparm 2 0 100/0 0.5 0 |
|
|
|
|
No subsequent fringes (narrow rate range), no fringes MOP-VSOP |
CALIB | refant=1;timer 0 4 0 0 0 6 30 0 |
|
|
|
|
zero the VSOP phases |
CLCAL | refant=1; |
|
|
|
|
|
KRING | timer 0 6 0 0 0 6 30; |
|
|
|
|
The split data looks to have flux on VSOP baselines to Shanghi, so have a bloody good look |
SPLIT | aparm(1)=2 0; |
|
|
|
|
Av within IF |
FITTP |
|
|
|
|
Data written out for analysis in Difmap amplitude |
AIPS Input Files
ANTAB.TXT | Comments used nominal_tsys.pl From SH log The hydrogen clock jumped two time during this experiment. Once is between UT:6:00 and 7:00. another is between UT:7:00 and 8:00. The average value of the work clock compare with gps is following: clock offset=utc(seshan25)-utc(gps)=25.595us at UT: 6:00. clock offset=utc(seshan25)-utc(gps)=317.355us at UT: 7:00. clock offset=utc(seshan25)-utc(gps)=638.480us at UT: 8:00. clock offset=utc(seshan25)-utc(gps)=638.522us at UT: 9:00. |
AIPS Output Files
Phase selfcal applied? | Yes |
Global amplitude selfcal (gscal) applied? | No |
Amplitude selfcal on non-global timescales used? | No |
Modelfit made and saved? | Yes |
Image Made and saved? | No |
Comments on Difmap processing
selfcalled on 30 sec timescale. Yuch. |
Modelfit | ||||
Ampl, Phase vs (u,v) Distance PS (16 kb) JPEG (34 kb) |
Ampl, Phase vs Time PS (68 kb) JPEG 1, 2 |
(u,v) Coverage PS (8 kb) JPEG (21 kb) | Closure Phase vs Time PS (46 kb) JPEG 1 |
Image with model components PS (25 kb) JPEG (34 kb) |
More details on the Images and Modelfits are found in this page.