VS02N Results
Submitted checklist.txt and checklist.tex is also available |
[Summary | AIPS | Difmap ] |
Abstract
Just HO to VSOP. Very weak signal. A single value for the delay is used, and then a delay search. This will cause some signal loss. Data calibrated with both IF's tied in AIPS to improve signal. Very complicated source, so only VSOP baselines here. Core may be slightly resolved. |
|
|
in |
in |
out |
out |
|
FITLD | clint = 0.25 digicor = -1 delcorr = -1 |
|
|
|
|
|
INDXR | cparm = 0, 0, 0.25; |
|
|
|
|
|
ANTAB | infile='antab.txt' |
|
|
|
|
|
APCAL |
|
|
|
|
||
ACCOR | solint 5 |
|
|
|
|
|
CLCAL | refant=1; |
|
|
|
|
Amplitude calibration solutions applied. Hobart as ref |
CLCAL | refant=1; |
|
|
|
|
Amplitude calibration solutions applied. Hobart as ref |
FRING | dparm 1,200,200,2,1,0;aparm(7)=0.1;solint 15,5,10 |
|
|
|
|
Good SNR (because of the high gain?), but scattered sols post 23:30. Best solution would be to assume zero rate & -10 nsec delay (equiv to 0.95 signal loss/gain) for whole experiment. Best does not equal good. |
TACOP |
|
|
|
|
||
CLCOR | opcode 'gain';antenna 0;clcorprm 1.13,0 opcode 'sbdl';antenna 2;clcorprm -10,-10,0 opcode 'gain';antenna 0;clcorprm 1/sqrt(1.13),0 |
|
|
|
|
Actually applied delay to all and VSOP one more time made a mistake in the correction value. |
FRING | dparm 2,-1,200,0.5;solint 5 |
|
|
|
|
Signal fades out after 00UT. |
SNEDT |
|
|
|
|
Smooth the rates (and zero the delays) | |
CLCAL | opty 'ambg' |
|
|
|
|
|
SPLIT | aparm(1)=2 0; |
|
|
|
|
Av within IF |
FITTP |
|
|
|
|
Data written out for analysis in Difmap |
AIPS Input Files
Comments Fringes not found at correlator post 23:30 UT |
AIPS Output Files
Phase selfcal applied? | No |
Global amplitude selfcal (gscal) applied? | No |
Amplitude selfcal on non-global timescales used? | No |
Modelfit made and saved? | Yes |
Image Made and saved? | Yes |
Comments on Difmap processing
Calibrated AIPS data base is in J0433_SC_AIPS.FITS, and phase fit combining to IFs is in SN_CALIB_PHA_2.PS Removed all ground data. Source is too complicated. About 0.57 Jy in slightly resolved core component Core size is 0.20 pm 0.08 |
Image | ||||
Ampl, Phase vs (u,v) Distance PS (17 kb) JPEG (36 kb) |
Ampl, Phase vs Time PS (32 kb) JPEG 1 |
(u,v) Coverage PS (11 kb) JPEG (24 kb) | Closure Phase vs Time PS (1 kb) JPEG 1 |
Clean Image PS (30 kb) JPEG (74 kb) |
Modelfit | ||||
Ampl, Phase vs (u,v) Distance PS (17 kb) JPEG (36 kb) |
Ampl, Phase vs Time PS (32 kb) JPEG 1 |
(u,v) Coverage PS (11 kb) JPEG (24 kb) | Closure Phase vs Time PS (1 kb) JPEG 1 |
Image with model components PS (39 kb) JPEG (43 kb) |
More details on the Images and Modelfits are found in this page.